-
1.
DEVELOPMENT OF TECHNOLOGY FOR THE SYNTHESIS OF HEAT-INSULATING GLASS-CRYSTALLINE MATERIALS BASED ON DRILLING MUD BY HYDRATE FOAMING
-
(Not-set)
-
This paper presents a study of the possibility of synthesizing a thermal insulation material, sludge, based on oil production drilling waste. Samples of drilling mud were collected at the Komsomolskoye ...
-
2.
SYNTHESIS OF MULLITE-SILICA CERAMICS WITH ENHANCED ELECTROPHYSICAL PROPERTIES
-
(Not-set)
-
Presents the results of the synthesis of mullite-silica ceramics with improved electrophysical characteristics based on natural kaolinite raw materials extracted in the Orenburg region. The main attention ...
-
3.
FEATURES OF GARNET PHASE FORMATION IN THE Y2O3–Lu2O3–Yb2O3–Ee2O3–Al2O3 SYSTEM IN THE SYNTHESIS OF NANOCRYSTALLINE LOW-AGGLOMERATED CERAMIC POWDERS BY COPRECIPITATION METHOD USING AMMONIUM ...
-
(Not-set)
-
For the first time a series of ceramic powders of the composition (Y1–xLux)3Yb0.15Er0.03Al5O12 (YLuAG) with a garnet structure in which the atomic ratio of Y3+/Lu3+ cations varied from 80/20 to 20/80, ...
-
4.
THE INFLUENCE OF THE ADDITION OF SLAG WASTE FROM THE NOVOCHERKASSK SDPP ON THE PROPERTIES OF ALUMINOSILICATE MATERIALS BASED ON DRILL WASTES FROM THE VOSTOCHNO-CHUMAKOVSKOYE OIL ...
-
(Not-set)
-
The essence of the method of horizontal drilling using hydraulic fracturing is described. The influence of drill wastes and coal combustion waste on the environment is shown. A number of physical and chemical ...
-
5.
Ecogeopolymers Based on Ash Waste CHPP – Prospective Materials for Road Construction in the Arctic Zone
-
(Not-set)
-
In the course of the study, the possibility of using ash and slag waste from the thermal power plant of the Arctic zone as raw materials for the production of porous ecogeopolymers was studied. The assessment ...
-
6.
Obtaining Hollow Glass microspheres and Their Application in the Production of Water-Dispersion Coatings
-
(Science for glass production)
-
The results of obtaining hollow glass microspheres and their effect on the properties of facade water-dispersion paints and varnishes when replacing titanium oxide and calcium carbonate in the formulation ...
-
7.
Cases Concerning the Use of Diagonal Plows in the Glass Mixture and Glass Cullet Transportation Lines
-
(Equipment)
-
The features of the use of plow dumpers in the lines for transporting the charge and cullet to the hoppers of the loaders of the glass furnace are considered. An improved design of a plow spreader equipped ...
-
8.
Anion-exchange synthesis of copper ferrite powders
-
(At the enterprises and institutes)
-
A method for the synthesis of copper ferrite is proposed, which consists in the anion-exchange precipitation of copper (II) and iron (III) from solutions of their salts in the presence of tartrate ions ...
-
9.
Radome vitrous materials based on titanosilicate glasses
-
(Science for glass and ceramic production)
-
Based on the R 2 O? BaO? TiO 2 ? SiO 2 system (where R 2 O? Li < sub> 2 O, K 2 O and Na 2 O) glass with low crystallization capacity has been developed; the value of the tangent of the angle ...
-
10.
Improvement of ceramics dielectric behaviour in centimeter MW-range by structure modification with pyrogenic silica nanoparticles
-
(Science for ceramic production)
-
The possibility of increasing the dielectric characteristics of ceramics by introducing nanosized particles of pyrogenic silicon dioxide (aerosil) into the charge is considered. It is shown that the introduction ...
-
11.
Analysis of sheet glass making process in large glass furnaces
-
(Science for glass production)
-
The analysis of the process of melting float glass in multi-tonnage glass-making furnaces has been carried out. The optimal values ??of the speed, duration of cooking and molten glass are determined. It ...
-
12.
Features of the thermo-stimulated
-
(Science for glass production)
-
It was found that when heated in air to 1100 ° C, the mass of silica glass fiber decreases by approximately 11%. In this case, mainly water is released into the gas phase. In addition to water in the gas ...
-
13.
Morphological approach to optimization of the molding compound properties for extrusion (review)
-
(Science for ceramic production)
-
The data characterizing the properties of molding masses for extrusion of complex-profile thin-walled products are presented. To characterize the molding properties of the masses, it was proposed to use ...
-
14.
Some aspects of basalt continuous fiber technology
-
(At the enterprises and institutes)
-
Some features of the mechanism of glass formation of basalt melt are presented. The influence of the characteristics of the basalt melt on the quality of continuous fibers is shown. The advantages of the ...
-
15.
Rating of the workability and adhesion properties of glass in glass fiber production
-
(Science for glass production)
-
The processes occurring during the production of glass fiber from glasses of various chemical compositions, as well as the influence of hydrostatic forces, surface tension forces and internal friction ...