-
1.
Intensification of sintering for low-melting clays upon variation of the firing atmosphere parameters
-
(Science for ceramic production)
-
It is shown that when a reduced pressure is created in the firing zone due to the released gases (Н 2 and CO), the nature of the gaseous medium becomes reductive, which contributes to an earlier reduction ...
-
2.
Laws of ceramic coloration based on low-melting clays
-
(Science for ceramic production)
-
The influence of the mineral composition of low-melting red-burning clays, gaseous medium and the nature of raw materials on the formation of a light (white) ceramic material as a result of crystallization ...
-
3.
Sintering of low-melting illite-containing clays
-
(Science for ceramic production)
-
On the basis of low-melting clay-containing clays with the addition of finely dispersed glass, a sintered ceramic material with a water absorption of less than 6% was obtained. The dependence of the properties ...
-
4.
Low-melting clays from Gzhelskoe deposite
-
(Science for ceramic production)
-
The physicochemical and technological properties of the Gzhel deposit clays have been studied. They can be recommended as the main type of raw material for the production of pottery and majolica products, ...
-
5.
A Comprehensive Evaluation of the Effect of Mineralogical Composition of Clays and Component from Porous Glass on the Thermal Conductivity and Frost Resistance Heat-Efficient Wall Ceramics
-
(Science for ceramic production)
-
The results of studies of the porosity of heat-efficient ceramic materials based on clays of various mineralogical composition with a glass-porous component (SPC) and their effect on frost resistance and ...
-
6.
Tyumen clays in constriction ceramics production
-
(Science for ceramic production)
-
The properties of three samples of low-melting clays (Tyumen region) were investigated for use in the production of ceramic building bricks. Found that clay samples? 1 and 3 can be used for the production ...
-
7.
Ceramic materials made of low-melt clays modified with glass fiber production waste
-
(Utilization of waste)
-
The use of waste from a fiberglass plant allows not only to solve a serious environmental problem, but also to improve the quality of building ceramics produced at brick factories.
-
8.
The reasons for different effect of lime clays on the strength characteristics of ceramics
-
(Science for ceramic production)
-
It is shown that an increase in the strength characteristics of ceramic products molded from weakly sintered polymineral low-melting clay raw materials and calcareous clays occurs due to an increase in ...
-
9.
Clays from Semikarakorskoe deposit
-
(Raw materials)
-
Clay of the Semikarakorsk deposit (Rostov region) was investigated for suitability for the production of ceramic products. Clay refers to low-melting polymineral hard-to-sinter clays, contains impurities ...
-
10.
GURLEN HYDROSLUIDIC CLAY IS A LOW-TEMPERATURE FLUX IN THE PRODUCTION OF CERAMICS
-
(Not-set)
-
As a result of a comprehensive study of the characteristics of the clay of the Gurlensky deposit, it was determined that the Gurlensky hydrosluidic clay, in its chemical composition, has a relatively high ...
-
11.
Relationship Between Properties, Phase Composition and Microstructure of Clinker Brick
-
(Not-set)
-
A clinker brick was obtained on the basis of polymineral raw materials, including low-melting and high-melting clays, loams and granitoid screenings with the plastic method of manufacturing. The relationship ...
-
12.
Analysis of the Couses of Efflorescence in Brickwork in the Aral Sea Region
-
(Not-set)
-
The analysis of the main reasons for the formation of efflorescence in brickwork in the Aral Sea regions is presented. It has been established that as a result of alternating moistening and drying of the ...
-
13.
Low-Shrink Ceramics Based on Dolerite Fine Waste of Crushed Stone Production
-
(Science for ceramic production)
-
The results of the possibility of using dolerite fine-grained waste of crushed stone production in ceramic charges for the manufacture of low-shrinkage products are presented. It was found that solid-phase ...
-
14.
Production of expanded clay gravel using galvanic wastewarer slurries
-
(Science for ceramic production)
-
The possibility of using sewage sludge from electroplating industries in the production of expanded clay has been studied. The relationship between the physicochemical and operational characteristics of ...
-
15.
Using of nontraditional raw materials for production of heat-resistant ceramics
-
(Science for ceramic production)
-
The possibility of using non-traditional raw materials for the production of heat-resistant cordierite-containing ceramics is shown. On the basis of refractory and low-melting Belarusian clays, cordierite-containing ...
-
16.
Dyeing of ceramic bricks
-
(Science for ceramic production)
-
... presented. It was found that in order to achieve an expanded color range of products, it is advisable to pre-bleach low-melting clays with chalk or refractory clay, kaolin, impregnated with solutions of ...
